Nanostructure CaCu2.90Zn0.10Ti4O12 (CCZTO) electronic ceramic was synthesized by semi‐wet route. The objective of this route is to enable the calcination and sintering processes to go for completion in shorter time and at lower temperature.The samples were characterized by XRD, TEM, SEM and EDX analyses. The crystallite size of the CCZTO ceramic, obtained by XRD using Debye Scherrer formula, range from 38‐74nm which is in good agreement with the particle size observed by TEM analysis. It was observed clearly that the grain size significantly increased with an increase in sintering duration. Dielectric measurements were carried out by LCR meter in the temperature range, 300‐ 500K, at few selected frequencies. It...
CCTO ceramics were synthesized by solid state reaction route. Calcination temperature was optimized....
A method of preparing the nanoparticles of $CaCu_3Ti_4O_{12}$ (CCTO) with the crystallite size varyi...
CaCu3Ti4O12 (CCTO) was prepared by a conventional synthesis (CS) and through reaction sintering, in ...
A facile way for the synthesis of nano-crystalline CaCu2.90Zn0.10Ti4O12 (CCZTO) using a solution com...
Nanocrystalline CaCu3Ti4O12 (CCTO) dielectric ceramics were prepared by a low-cost sol–gel technique...
CCTO powders were prepared by solid state reaction and mechanochemically, respectively. Synthesized ...
This paper reports on synthesis of polycrystalline complex perovskite CaCu3Ti4O12 (as CCTO) ceramic ...
Nanocrystalline CaCu3Ti4O12 ceramic powders of particle size ranging from 50 to 70 nm have been grow...
CaCu3Ti4O12 (CCTO) powder was synthesized by the combustion method. The effect of sintering temperat...
AbstractCaCu3Ti4O12 (CCTO) ceramics was prepared by solid state method. The raw materials of CaCO3, ...
Nanocrystalline powders of giant dielectric constant material, $CaCu_{3}Ti_{4}O_{12}$(CCTO), have b...
CaCu3Ti4O12 (CCTO) ceramics was prepared by solid state method. The raw materials of CaCO3, CuO, an...
Electroceramic is a part of ceramic, which is advanced material used for electrical properties. Elec...
$CaCu_3Ti_4O_1_2$ (CCTO) was synthesized and sintered by microwave processing at 2⋅45 GHz, 1⋅1 kW. T...
AbstractThe effect of calcination temperature on the properties of CaCu3Ti4O12 (CCTO) ceramics was s...
CCTO ceramics were synthesized by solid state reaction route. Calcination temperature was optimized....
A method of preparing the nanoparticles of $CaCu_3Ti_4O_{12}$ (CCTO) with the crystallite size varyi...
CaCu3Ti4O12 (CCTO) was prepared by a conventional synthesis (CS) and through reaction sintering, in ...
A facile way for the synthesis of nano-crystalline CaCu2.90Zn0.10Ti4O12 (CCZTO) using a solution com...
Nanocrystalline CaCu3Ti4O12 (CCTO) dielectric ceramics were prepared by a low-cost sol–gel technique...
CCTO powders were prepared by solid state reaction and mechanochemically, respectively. Synthesized ...
This paper reports on synthesis of polycrystalline complex perovskite CaCu3Ti4O12 (as CCTO) ceramic ...
Nanocrystalline CaCu3Ti4O12 ceramic powders of particle size ranging from 50 to 70 nm have been grow...
CaCu3Ti4O12 (CCTO) powder was synthesized by the combustion method. The effect of sintering temperat...
AbstractCaCu3Ti4O12 (CCTO) ceramics was prepared by solid state method. The raw materials of CaCO3, ...
Nanocrystalline powders of giant dielectric constant material, $CaCu_{3}Ti_{4}O_{12}$(CCTO), have b...
CaCu3Ti4O12 (CCTO) ceramics was prepared by solid state method. The raw materials of CaCO3, CuO, an...
Electroceramic is a part of ceramic, which is advanced material used for electrical properties. Elec...
$CaCu_3Ti_4O_1_2$ (CCTO) was synthesized and sintered by microwave processing at 2⋅45 GHz, 1⋅1 kW. T...
AbstractThe effect of calcination temperature on the properties of CaCu3Ti4O12 (CCTO) ceramics was s...
CCTO ceramics were synthesized by solid state reaction route. Calcination temperature was optimized....
A method of preparing the nanoparticles of $CaCu_3Ti_4O_{12}$ (CCTO) with the crystallite size varyi...
CaCu3Ti4O12 (CCTO) was prepared by a conventional synthesis (CS) and through reaction sintering, in ...