A Feasibility Study on Using Gfrp Composites Bar in Rc Flexural Member

Steel reinforcements are commonly used for Reinforced Concrete (RC) beams all around the world to take flexural tension. But, the durability of the structure is reduced due to reinforcement steel corrosion. Avoiding reinforcement corrosion and finding alternative material to take flexural tension is the contemporary research work in the field of structural engineering. In the present study, RC beams are reinforced with Glass Fibre Reinforced polymer (GFRP) composites bar at tension zone and flexural test was carried out to determine the bending moment resistance of the beam. GFRP bars were prepared in the industry with the help of pultruded U-section box formwork. GFRP bars were coated with sand using epoxy resin to increase the bond between bars and the RC beam. Three GFRP reinforced concrete beam specimens of size 700 mm × 200 mm × 200 mm were prepared. Also, same size of normal steel reinforced cement concrete beam member was prepared. After 28 days curing, three point bending test was carried out for all the four beams. Flexural capacity of beams with GFRP bars were compared with RC beam with steel bars. The results revealed that the flexural capacity of RC beams with GFRP bars is more than that of RC beam with steel bars. Also, theoretical analysis was carried out to determine the flexural strength of RC beam with steel and GFRP bars and compared with experimental results