Multiple shape-memory behavior and thermal-mechanical properties of peroxide cross-linked blends of linear and short-chain branched polyethylenes

Thermally induced shape-memory effect (SME) in tensile mode was investigated in binary and ternary blends of two ethylene-1-octene copolymers with a degree of branching of 30 and 60 CH3/1000C and/or nearly linear polyethylene cross-linked after melt mixing with 2 wt% of liquid peroxide 2,5-dimethyl-2,5-di-(tert.butylperoxy)-hexane at 190°C. The average cross-link density estimated by means of the Mooney-Rivlin equation on the basis of tensile test data was characterized between 130 and 170 mol•m–3 depending on the blend composition. Thermal analysis points out multiple crystallization and melting behavior of blends caused by the existence of several polyethylene crystal populations with different perfection, size and correspondingly different melting temperature of crystallites. That agrees well with the diversity of blends phase morphology characterized by atomic force microscopy. However, triple- and quadruple-SME could be observed only after two- and accordingly three-step programming of binary and tertiary blends, respectively, at suitable temperatures and strains. Compared to performances obtained for the same blend after single-step programming above the maximal melting temperature the significantly poorer characteristics of SME like strain fixity and strain recovery ratio as well as recovery strain rate occurred after multi-step programming