Transformation behaviour, bending properties and surface quality of 22 commercial nickel-titanium wires: A batch-to-batch evaluation

Aims: The aims of this study were to investigate batch-to-batch differences in mechanical and thermal properties of 22 commercial nickel-titanium wires and evaluate the surface quality. Secondly the percentages of superelasticity at mouth temperature were measured. Study Design: In vitro laboratory study. Place and Duration of Study: Sample: Department of Oral Health Sciences – Orthodontics and Metallurgy and Materials Engineering KU Leuven, between January 2010 and May 2011. Methodology: The sample comprised 22 NiTi wires of the upper jaw from 7 different manufacturers. For each brand two different batches were investigated (LOT A, LOT B). Three different investigations were carried out. First transformation behaviour and transition temperatures were determined by differential scanning calorimetry, second a three point bending test was done to evaluate the mechanical properties and third scanning electron microscopy was performed on all samples to evaluate surface quality. Results: Absolute batch-to-batch differences in the investigated properties were all deviating from zero, although most differences were clinically acceptable. Significant interbatch differences in thermal properties were found in 4 wires. Mechanical interbatch differences were found remarkable for 5 wires. Percentage of elasticity showed a non-superelastic curve below a deflection of 1500 μm, which represents clinical small deflections. Surface topography showed also interbatch differences for 4 wires. Conclusion: This study shows that batch-to-batch differences are obvious in each sample. One has to be careful in the selection of archwires. Therefore more standardized consument information should be provided.status: publishe