Diamond drilling of Carbon Fiber Reinforced Polymers: Influence of tool grit size and process parameters on workpiece delamination

The physical and mechanical properties of advanced composite materials promote their application in structural components for the aerospace and automotive sectors. However, limitations in their machinability are due to anisotropy/inhomogeneity, poor plastic deformation, and abrasive behavior. For CFRP drilling, the process efficiency is heavily influenced by cutting conditions and tool geometry. This paper reports the outcomes of experimental diamond drilling tests. A 4-mm thick carbon-epoxy composite laminate was machined. The plate was made of ten layers, in which the carbon fibers were intertwined at 90°. 6-mm diameter core drills were used. Core drills were characterized by an electroplated bond type and an AC32-H diamond grain type. Four different tool grit size ranges were tested: (1) 63/53 μm, (2) 125/106 μm, (3) 212/180 μm, and (4) 212/180 plus 63/53 μm. The results are reported in terms of workpiece delamination, thrust force, torque, and chip morphology. Overall, the results allow identifying the cutting conditions for the minimum drilling-induced delamination while retaining a satisfactory process productivity