Fault Tolerant Electronic System Design

Due to technology scaling, which means reduced transistor size, higher density, lower voltage and more aggressive clock frequency, VLSI devices may become more sensitive against soft errors. Especially for those devices used in safety- and mission-critical applications, dependability and reliability are becoming increasingly important constraints during the development of system on/around them. Other phenomena (e.g., aging and wear-out effects) also have negative impacts on reliability of modern circuits. Recent researches show that even at sea level, radiation particles can still induce soft errors in electronic systems. On one hand, processor-based system are commonly used in a wide variety of applications, including safety-critical and high availability missions, e.g., in the automotive, biomedical and aerospace domains. In these fields, an error may produce catastrophic consequences. Thus, dependability is a primary target that must be achieved taking into account tight constraints in terms of cost, performance, power and time to market. With standards and regulations (e.g., ISO-26262, DO-254, IEC-61508) clearly specify the targets to be achieved and the methods to prove their achievement, techniques working at system level are particularly attracting. On the other hand, Field Programmable Gate Array (FPGA) devices are becoming more and more attractive, also in safety- and mission-critical applications due to the high performance, low power consumption and the flexibility for reconfiguration they provide. Two types of FPGAs are commonly used, based on their configuration memory cell technology, i.e., SRAM-based and Flash-based FPGA. For SRAM-based FPGAs, the SRAM cells of the configuration memory highly susceptible to radiation induced effects which can leads to system failure; and for Flash-based FPGAs, even though their non-volatile configuration memory cells are almost immune to Single Event Upsets induced by energetic particles, the floating gate switches and the logic cells in the configuration tiles can still suffer from Single Event Effects when hit by an highly charged particle. So analysis and mitigation techniques for Single Event Effects on FPGAs are becoming increasingly important in the design flow especially when reliability is one of the main requirements