Minimum quantity lubrication (MQL) technologies using vegetable oil lubricants as cutting fluids have attracted much attention as they have excellent machining performance and are environmentally friendly. Nevertheless, oil-based MQL tends to produce high cutting temperatures owning to the low cooling capability of oil lubricants. In this work, an MQL technology that utilizes graphene oxide/silicon dioxide (GO/SiO) hybrid nanoparticle water-based lubricants as cutting fluids was developed, and its tribological and machining characteristics were comparatively investigated using four-ball and milling testing units. The mass ratio of GO to SiO was also varied to achieve optimal performance. The results showed that GO/SiO water-based MQL reduce...
In minimum quantity lubrication (MQL), an aerosol containing a minimum amount of the cutting fluid i...
A lubricant is a substance introduced between surfaces in mutual contact to reduce friction, which u...
The significant amount of heat and friction generated in machining Ti-6Al-4V affects the cutting per...
To improve machining performance and lower oil mist concentration in machining workshops, a near-dry...
Water-based slurries with silica (SiO2) nanoparticles, graphene oxide (GO) nanosheets and GO/SiO2 hy...
Owing to the extreme heat generated during Inconel 718 machining, the application of a minimum quant...
This paper presents an investigation into the minimum quantity lubrication mode with Nano fluid duri...
Friction and very high temperature are still the major challenges in hard machining technology and t...
Efficient and effective lubricants have great application prospects in the manufacturing industries....
Cutting fluids significantly improve machining efficiency due to their high contribution to cooling ...
Manufacturing industries have been pressured to use less power and reduce pollution by the developme...
Abstract: Turning is one of the key and crucial processes of metal removal in industry. Increasing p...
Master's thesis in Petroleum engineeringThe objective was to improve conventional water based drilli...
There are many companies worldwide that would like to improve and upgrade the lube oil and enhance i...
The search of finding best vegetable oil based nanofluid from a set of three nanoparticle enriched c...
In minimum quantity lubrication (MQL), an aerosol containing a minimum amount of the cutting fluid i...
A lubricant is a substance introduced between surfaces in mutual contact to reduce friction, which u...
The significant amount of heat and friction generated in machining Ti-6Al-4V affects the cutting per...
To improve machining performance and lower oil mist concentration in machining workshops, a near-dry...
Water-based slurries with silica (SiO2) nanoparticles, graphene oxide (GO) nanosheets and GO/SiO2 hy...
Owing to the extreme heat generated during Inconel 718 machining, the application of a minimum quant...
This paper presents an investigation into the minimum quantity lubrication mode with Nano fluid duri...
Friction and very high temperature are still the major challenges in hard machining technology and t...
Efficient and effective lubricants have great application prospects in the manufacturing industries....
Cutting fluids significantly improve machining efficiency due to their high contribution to cooling ...
Manufacturing industries have been pressured to use less power and reduce pollution by the developme...
Abstract: Turning is one of the key and crucial processes of metal removal in industry. Increasing p...
Master's thesis in Petroleum engineeringThe objective was to improve conventional water based drilli...
There are many companies worldwide that would like to improve and upgrade the lube oil and enhance i...
The search of finding best vegetable oil based nanofluid from a set of three nanoparticle enriched c...
In minimum quantity lubrication (MQL), an aerosol containing a minimum amount of the cutting fluid i...
A lubricant is a substance introduced between surfaces in mutual contact to reduce friction, which u...
The significant amount of heat and friction generated in machining Ti-6Al-4V affects the cutting per...