The Design of a Debugger Unit for a RISC Processor Core

Recently, there has been a significant increase in design complexity for Embedded Systems often referred to as Hardware Software Co-Design. Complexity in design is due to both hardware and firmware closely coupled together in-order to achieve features for low power, high performance and low area. Due to these demands, embedded systems consist of multiple interconnected hardware IPs with complex firmware algorithms running on the device. Often such designs are available in bare-metal form, i.e without an Operating System, which results in difficulty while debugging due to lack of insight into the system. As a result, development cycle and time to market are increased. One of the major challenges for bare-metal design is to capture internal data required during debugging or testing in the post silicon validation stage effectively and efficiently. Post-silicon validation can be performed by leveraging on different technologies such as hardware software co-verification using hardware accelerators, FPGA emulation, logic analyzers, and so on which reduces the complete development cycle time. This requires the hardware to be instrumented with certain features which support debugging capabilities. As there is no standard for debugging capabilities and debugging infrastructure, it completely depends on the manufacturer to manufacturer or designer to designer. This work aims to implement minimum required features for debugging a bare-metal core by instrumenting the hardware compatible for debugging. It takes into consideration the fact that for a single core bare-metal embedded systems silicon area is also a constraint and there must be a trade-off between debugging capabilities which can be implemented in hardware and portions handled in software. The paper discusses various debugging approaches developed and implemented on various processor platforms and implements a new debugging infrastructure by instrumenting the Open-source AMBER 25 core with a set of debug features such as breakpoints, current state read, trace and memory access. Interface between hardware system and host system is designed using a JTAG standard TAP controller. The resulting design can be used in debugging and testing during post silicon verification and validation stages. The design is synthesized using Synopsys Design Compiler targeting a 65 nm technology node and results are compared for the instrumented and non-instrumented system