Capabilities for calibrations of angular deviations of sensor triplets in precise magnetometers were evaluated in a 2.5-meter, triaxial Helmholtz-coil facility. The coil system is located in a magnetically quiet environment at SANSA Space Science in Hermanus, South Africa. The angular calibration results obtained from the "thin-shell" calibration procedure were compared with direct measurements on a non-magnetic tilting/rotational platform
The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (Finland) i...
Abstract: The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (...
The paper describes a three-step estimator to calibrate a Three-Axis Magnetometer (TAM) using TAM an...
Magnetometer calibration is normally performed using shielded (or otherwise magnetically benign) coi...
This article presents an innovative in-field calibration method for portable triaxial magnetometers ...
Two methods were tested for calibration procedures of the 3D coil system which is used as a source p...
Advisors: Michael J. Haji-Sheikh.Committee members: Veysel Demir; Donald S. Zinger.In this thesis, t...
Heading angle of magnetic compasses is estimated using the triaxial magnetometer readings. The accur...
Magnetometers combined with inertial sensors are widely used for orientation estimation, and calibra...
A tri-axial square Helmholtz coil system for the study of palaeomagnetic studies, manufactured by G...
Abstract — This paper reports on a novel method for esti-mating the sensor bias of three-axis magnet...
ABSTRACT This article deals with the problem of Earth’s magnetic field sensors calibration in the co...
© 2015 IEEE. The calibration and its associated experimental design scheme for the tri-axial magneto...
Abstract: There is a three-component magnetometer SM-8M onboard Service Module of ISS. It ...
Rigid body orientation can be estimated in a "sourceless manner" through the use of small three degr...
The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (Finland) i...
Abstract: The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (...
The paper describes a three-step estimator to calibrate a Three-Axis Magnetometer (TAM) using TAM an...
Magnetometer calibration is normally performed using shielded (or otherwise magnetically benign) coi...
This article presents an innovative in-field calibration method for portable triaxial magnetometers ...
Two methods were tested for calibration procedures of the 3D coil system which is used as a source p...
Advisors: Michael J. Haji-Sheikh.Committee members: Veysel Demir; Donald S. Zinger.In this thesis, t...
Heading angle of magnetic compasses is estimated using the triaxial magnetometer readings. The accur...
Magnetometers combined with inertial sensors are widely used for orientation estimation, and calibra...
A tri-axial square Helmholtz coil system for the study of palaeomagnetic studies, manufactured by G...
Abstract — This paper reports on a novel method for esti-mating the sensor bias of three-axis magnet...
ABSTRACT This article deals with the problem of Earth’s magnetic field sensors calibration in the co...
© 2015 IEEE. The calibration and its associated experimental design scheme for the tri-axial magneto...
Abstract: There is a three-component magnetometer SM-8M onboard Service Module of ISS. It ...
Rigid body orientation can be estimated in a "sourceless manner" through the use of small three degr...
The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (Finland) i...
Abstract: The calibration system for vector DC magnetometers of Nurmijarvi Geophysical Observatory (...
The paper describes a three-step estimator to calibrate a Three-Axis Magnetometer (TAM) using TAM an...