Investigation of three-dimensional structure of fine scales in a turbulent jet by using cinematographic stereoscopic particle image velocimetry

Cinematographic stereoscopic particle image velocimetry measurements were performed to resolve small and intermediate scales in the far field of an axisymmetric co-flowing jet. Measurements were performed in a plane normal to the axis of the jet and the time-resolved measurement was converted to quasi-instantaneous three-dimensional data by using Taylor's hypothesis. The quasi-instantaneous three-dimensional data enabled computation of all nine components of the velocity gradient tensor over a volume. The results based on statistical analysis of the data, including computation of joint p.d.f.s and conditional p.d.f.s of the principal strain rates, vorticity and dissipation, are all in agreement with previous numerical and experimental studies, which validates the quality of the quasi-instantaneous data. Instantaneous iso-surfaces of the principal intermediate strain rate (beta) show that sheet-forming strain fields (i.e. beta > 0) are themselves organized in the form of sheets, whereas line-forming strain fields (beta < 0) are organized into smaller spotty structures (not lines). Iso-surfaces of swirling strength (a vortex identification parameter) in the volume reveal that, in agreement with direct numerical simulation results, the intense vortex structures are in the form of elongated 'worms' with characteristic diameter of approximately 10 eta and characteristic length of 60-100 eta. Iso-surfaces of intense dissipation show that the most dissipative structures are in the form of sheets and are associated with clusters of vortex tubes. Approximately half of the total dissipation occurs in structures that are generally sheet-like, whereas the other half occurs in broad indistinct structures. The largest length scale of dissipation sheets is of order 60 eta and the characteristic thickness (in a plane normal to the axis of the sheet) is about 10 eta. The range of scales between 10 eta (thickness of dissipation sheets, diameter of vortex tubes) to 60 eta (size of dissipation sheet or length of vortex tubes) is consistent with the bounds for the dissipation range in the energy and dissipation spectrum as inferred from the three-dimensional model energy spectrum