Add to ORKGDetermination of drag coefficients from the conventional plots of drag coefficient versus Reynolds number is inadequate in the case of turbulent flow
The purpose of this work is to clarify the causes of non-ideal behavior observed in the current-volt...
A method is presented for analyzing the elastic-plastic behavior of frames which account for the red...
Tests were conducted in a specially constructed fatigue machine which allowed the maintenance of a s...
The upper bound approach is used to analyze combined backward-forward extrusion. The deformation reg...
This thesis evaluates the effect of forced air, free flow and spray mist application of cutting flui...
This thesis pertains to an experimental investigation of the effect on a turbulent radial wall jet w...
Since McWhorter suggested that flicker noise is related to surface states in semiconductor devices, ...
The basic operational amplifier was tested for static gain characteristics and frequency response. ...
The effect of a leading edge flap on the aerodynamics of a low aspect ratio delta wing is studied an...
This thesis present an analysis of the relation between intermodulation distortion and harmonic dist...
The objectives of this investigation were established to be as follows: (1) To study the pressure de...
Flight tests were made with a Kellett YG-1 autogiro to determine the relationship between the ground...
Infrared absorption measurements have been used to study the precipitation rate of oxygen in silicon...
The purpose of this thesis is to investigate the use of Adaptive Control to monitor a turning operat...
Little experimental evidence is available as to the presence or the extent of interitem differences ...
The purpose of this work is to clarify the causes of non-ideal behavior observed in the current-volt...
A method is presented for analyzing the elastic-plastic behavior of frames which account for the red...
Tests were conducted in a specially constructed fatigue machine which allowed the maintenance of a s...
The upper bound approach is used to analyze combined backward-forward extrusion. The deformation reg...
This thesis evaluates the effect of forced air, free flow and spray mist application of cutting flui...
This thesis pertains to an experimental investigation of the effect on a turbulent radial wall jet w...
Since McWhorter suggested that flicker noise is related to surface states in semiconductor devices, ...
The basic operational amplifier was tested for static gain characteristics and frequency response. ...
The effect of a leading edge flap on the aerodynamics of a low aspect ratio delta wing is studied an...
This thesis present an analysis of the relation between intermodulation distortion and harmonic dist...
The objectives of this investigation were established to be as follows: (1) To study the pressure de...
Flight tests were made with a Kellett YG-1 autogiro to determine the relationship between the ground...
Infrared absorption measurements have been used to study the precipitation rate of oxygen in silicon...
The purpose of this thesis is to investigate the use of Adaptive Control to monitor a turning operat...
Little experimental evidence is available as to the presence or the extent of interitem differences ...
The purpose of this work is to clarify the causes of non-ideal behavior observed in the current-volt...
A method is presented for analyzing the elastic-plastic behavior of frames which account for the red...
Tests were conducted in a specially constructed fatigue machine which allowed the maintenance of a s...