On the influence of salt concentration on the transport properties of reverse osmosis membranes in high pressure and high recovery desalination

In this work, we investigate the effect of varying the concentration of sodium chloride up to 70 g L−1 - equivalent to a recovery of approximately 50% in seawater desalination-on the transport properties of different reverse osmosis membranes. The study was performed using five commercial thin film composite (TFC) membranes and an analogue TFC membrane fabricated via the interfacial reaction of m-phenylenediamine and trimesoyl chloride. The surface properties of the membranes as measured by atomic force microscopy (AFM), zeta potential, and X-ray photoelectron spectroscopy (XPS) are presented. The solution diffusion model coupled with film theory was used to calculate the permeance of water and salt through the membranes, to account for the effect of concentration polarisation. The mass transfer coefficient in the test cells was estimated independently using the dissolution rate of benzoic acid; and was found to be approximately . A linear reduction in salt permeance was observed in some of the RO membranes, while it remained constant for other membranes, including the analogue membrane. All the tested membranes maintained constant water permeance below 45 g L−1 NaCl. However, when the salt concentration at the membrane surface exceeded 45 g L−1, water permeance either increased, remained constant or decreased. The results demonstrate the dependence of water and salt transport on the concentration of sodium chloride at the membrane surface