Design of topologically optimized upright for pneumobil race car

This thesis deals with the design of lightweight front uprights of pneumobile Javelin using topology optimization, followed by manufacturing by additive technology Selective Laser Melting. Aluminium alloy AlSi10Mg was used. Topology optimized parts should have met the requirement of minimal safety factor equal to 2, therefore the stress strain analysis was performed using FEM. The maximal deformation was determined and the safety factor obtained. Two unsymmetrical uprights were designed due to parameters of the brake system. The precision of manufacturing was verified by optical digitization. Machined uprights were mounted on the pneumobile and tested directly on the vehicle. No limit states were observed during testing and subsequent races, so they proved to be fully functional. Weight of the left upright was reduced from 1 609 g to 758 g, the right one was lightened to 741 g