Effect of Co on the phase stability of CrMnFeCo<inf>x</inf>Ni high entropy alloys following long-duration exposures at intermediate temperatures

The effect of Co on the phase stability of the CrMnFeCoxNi family of alloys, where the atomic ratio x = 0, 0.5, 1.5, has been experimentally established following 1000 hour heat treatments at 700 and 900˚C and up to 5000 hours at 500˚C. All the alloys were single phase fcc in the homogenised condition, except for CrMnFeNi which also contained bcc precipitates that remained present following exposures at 900˚C and 700˚C. The exposures at 900˚C and 700˚C also resulted in the formation of σ phase precipitates in the CrMnFeNi and CrMnFeCo0.5Ni alloys but not in the CrMnFeCo1.5Ni alloy. These data, in conjunction with results previously published in the literature, conclusively establish that Co stabilises the fcc matrix at elevated temperatures. However, at 500˚C, further bulk decomposition in the CrMnFeNi alloy was observed and produced a fine-scale intergrowth of a NiMn L10 phase and CrFe σ phase. Grain boundary precipitates were also observed following exposure at 500˚C in the CrMnFeCo0.5Ni and CrMnFeCo1.5Ni alloys. Four different phases were observed on the grain boundaries of the CrMnFeCo0.5Ni alloy (Cr carbide, σ, FeCo B2 and NiMn L10), whilst only two phases were found on the grain boundaries of the CrMnFeCo1.5Ni alloy (Cr carbide and NiMn L10). The experimental observations facilitated an assessment of the fidelity of current thermodynamic predictions of phase equilibria. All the phases predicted were observed experimentally and the σ stability fitted the experimental observations well. However, at lower temperatures, thermodynamic predictions were less consistent with experimental observations, underpredicting the extent of the B2 phase field and failing to predict the formation of the L10 phase