Measurement of frequency-dependent dynamic properties of soils using the resonant column device

Dynamic properties of soils are commonly evaluated at resonance; thus, their variation with frequency is difficult to measure. A nonresonance (NR) method has been recently used for testing soils at low frequencies and strain levels below the linear threshold shear strain. However, the NR method has not been validated with the standard resonant method for different shear strain levels. In this study, the NR method is used to measure the dynamic properties of soils at low and midstrain levels for a maximum frequency bandwidth between 5 and 100 Hz using the resonant-column device. A new transfer function (NTF) equation is introduced to compare the dynamic properties measured using the NR method and the conventional transfer function approach. Experimental results for two sands and a sand–bentonite–mud mixture are presented for different strain and stress confinement levels. Results from the NR method compare well with the standard resonant column method at the resonant frequency if the strain levels are the same. The NTF approach can be used to measure the dependence of phase velocity of shear waves with frequency. However, the NTF method cannot be used to measure the variation of material damping with frequency. On the other hand, the NR method can be used to measure the degradation curves of wave velocity and material damping ratio as a function of frequency