The thermal and total epithermal neutron flux distributions in the EGCR from the center of the core through the biological shield were calculated. The maximum values of the flux distribution are presented in graph form. Ordinary concrete was found to permit a thermal flux buildup, similar to that found in the graphite reflector. In heavy concrete there was no such buildup seen, since the thermal flux is attenuated through the complete shield. A Val Prod code using multigroup diffusion theory was used to calculate the neutron flux distributions. Calculations are shown. (M.C.G.
This report supersedes sections of the following ANL Metallurgy Division Quarterly Reports: ANL-5489...
Abstract. Neutron diffusion length in reactor grade graphite is measured both experimentally and the...
Work performed at the Atomic Energy Division, Phillips Petroleum Company, Idaho Falls, Idaho."Date D...
"Submitted as a thesis to the Graduate Council of the University of Tennessee in partial fulfillment...
The European Safety and Environmental Assessment of Fusion Power (SEAFP-2) program deals with safet...
BS>When radiation shields are penetrated by ducts, the gamma rays resulting from the radiative captu...
Neutron flux in the side regions of the High Temperature Gas Cooled Reactor\u27s (HTGR) Prestressed ...
The neutron flux distributions in an EGCR cell containing seven and clusters of 2.0 and 2.6a enriche...
Neutron activation analysis was used to determine the thermal and epithermal neutron flux and its sp...
In this report the problem is considered of determining neutron flux distributions in reactors consi...
Results of investigations concerning the radial leakage flux of neutrons greater than 1 Mev at the E...
"Operated by the University of Chicago under Contract W-31-109-eng-38.""Metallurgy Division Program ...
A method is presented for calculating thermal neutron fluxes in the primary shields of reactor syste...
Measurements were made in the Process Revelopment Pile (PDP) of the distribution of the thermal neut...
The thermal column in the ET-RR-2 reactor is intended to promote a thermal neutron field of high int...
This report supersedes sections of the following ANL Metallurgy Division Quarterly Reports: ANL-5489...
Abstract. Neutron diffusion length in reactor grade graphite is measured both experimentally and the...
Work performed at the Atomic Energy Division, Phillips Petroleum Company, Idaho Falls, Idaho."Date D...
"Submitted as a thesis to the Graduate Council of the University of Tennessee in partial fulfillment...
The European Safety and Environmental Assessment of Fusion Power (SEAFP-2) program deals with safet...
BS>When radiation shields are penetrated by ducts, the gamma rays resulting from the radiative captu...
Neutron flux in the side regions of the High Temperature Gas Cooled Reactor\u27s (HTGR) Prestressed ...
The neutron flux distributions in an EGCR cell containing seven and clusters of 2.0 and 2.6a enriche...
Neutron activation analysis was used to determine the thermal and epithermal neutron flux and its sp...
In this report the problem is considered of determining neutron flux distributions in reactors consi...
Results of investigations concerning the radial leakage flux of neutrons greater than 1 Mev at the E...
"Operated by the University of Chicago under Contract W-31-109-eng-38.""Metallurgy Division Program ...
A method is presented for calculating thermal neutron fluxes in the primary shields of reactor syste...
Measurements were made in the Process Revelopment Pile (PDP) of the distribution of the thermal neut...
The thermal column in the ET-RR-2 reactor is intended to promote a thermal neutron field of high int...
This report supersedes sections of the following ANL Metallurgy Division Quarterly Reports: ANL-5489...
Abstract. Neutron diffusion length in reactor grade graphite is measured both experimentally and the...
Work performed at the Atomic Energy Division, Phillips Petroleum Company, Idaho Falls, Idaho."Date D...