Relating quantitative soil structure metrics to saturated hydraulic conductivity

Soil structure affects saturated hydraulic conductivity (Ks) by creating highly conductive macropores that preferentially transmit soil water. In this study, we explore the relationship between Ks and macropores in an Oxyaquic Vertic Argiudoll in northeastern Kansas. Macropores were quantified from an excavation wall using multistripe laser triangulation (MLT) scanning. Soil water contents were measured at four depths within a soil lysimeter installed within 2 meters of the MLT-scanned soil profile and adjacent to an Ameriflux tower monitoring precipitation, air temperature, and solar radiation. Selected hydraulic properties of soil horizons within the lysimeter were optimized to water content data using a Markov chain Monte Carlo technique in combination with the mobile-immobile water (MIM) model in HYDRUS-1D. Estimates of Ks varied between 4198 cm d-1 in the A horizon and 0.6 cm d-1 in a 2Btss2 horizon with strongly expressed wedge structure. Approximately 87% of the variation in Ks was explained by the geometric mean of the widths of pores quantified with the MLT technique and modified by the coefficient of extensibility (COLE). The use of COLE allows the widths of the macropores obtained at dry conditions to be approximated at saturation. Two models that predict Ks from either texture or water retention data resulted in Ks estimates that were similar to each other, but significantly lower than Ks values predicted with MIM in horizons where structural pores dominate water flow. This technique shows a great deal of promise in better understanding and predicting the relationship of soil structure to water flow.Peer reviewe