Compréhension de la modulation du travail de sortie de métaux de grille pour l’intégration à bas budget thermique du CMOS 20-14 nm

To continue CMOS scaling, the HfO2/metal gate stack replaced the historical SiO2/PolySi gate stack. But the uncontrolled interdiffusion and reactivities of the new gate materials integrated with the classical high thermal budget approach appear to be a roadblock to reach the effective work function (EWF) and equivalent oxide thickness (EOT) ITRS targets. One solution consisted in implementing an approach with a lower thermal budget. Using this new approach, the aim of this thesis work was to understand the physical mechanisms, which enable to reach an EOT<1nm and an EWF relevant for nMOS and pMOS co-integration as required for the next 20-14nm CMOS nodes. Using spatially resolved TEM/EDX analyses and macroscopic TOF-SIMS and XPS techniques, elemental distributions and chemical bonds across nanometric-sized stacks were discussed and, based on thermodynamic considerations, correlated with the measured EWF and EOT. We showed for the first time that the modulation of nitrogen during TiAlN deposition on HfO2 results in a ~0.8eV EWF shift between the N-poor and N-rich HfO2/TiAlNx electrodes. The TiAlN complex system was understood after the identification of the EWF and EOT modulation mechanisms in the simple gate stacks TiN/Ti, Al or TiAl. Although TiAlNx electrodes define the best compromise for a variable EWF with a sub-nm EOT, it exhibits a low thermal stability. Therefore, we investigated two simpler metallic and stable systems using TaNix and NiTix alloys resulting from thermally assisted Ni-Ta and Ni-Ti interdiffusion in HfO2/Ta/Ni and HfO2/Ni/Ti stacks, respectively. These Ni-based electrodes are shown to be promising for a low thermal budget CMOS co-integration.Afin de poursuivre la miniaturisation des dispositifs CMOS, l’empilement HfO2/Métal a remplacé l’empilement SiO2/polySi. Cependant, la diffusion incontrôlée des espèces chimiques dans ces nouveaux empilements fabriqués avec un fort budget thermique compromet l’obtention des travaux de sortie (EWF) et des épaisseurs d’oxyde équivalent (EOT) définis par l’ITRS. Une solution consiste à utiliser une intégration à plus bas budget thermique. Avec cette nouvelle approche, l’objectif de ce travail de thèse était de comprendre les paramètres physiques permettant d’obtenir une EOT