Effects of Machine Parameters on Surface Roughness Using Response Surface Method in Drilling Process

AbstractThe optimization of surface integrity in drilling process using response surface method (RSM) is presented. This paper investigates the effects of drilling parameter such as spindle speed, feed rate and drill diameter on the surface roughness and surface texture of drilled hole by applying RSM. There are three factors (spindle speed, feed rate and drill diameter) under investigation, therefore, by applying RSM there will be 20 experimental observations. The minimum surface roughness measured for the hole was 1.06μm at combination of 2000rpm spindle speed, 78mm/min feed rate and 2.5mm drill diameter. While the maximum surface roughness of 2.59μm was measured at the combination of 250rpm spindle speed, 153mm/min feed rate and 3.5mm drill diameter. One factor plot analysis found that the most significant parameter was spindle speed followed by drill diameter and feed rate. Thus, surface roughness decreased when increasing the spindle speed, feed rate and drill diameter. There were interactions between all the parameter of spindle speed, feed rate and drill diameter in drilling process under investigation