Effect of geometric imperfections on the ultimate moment capacity of cold-formed sigma-shape sections

AbstractIn recent years, cold formed steel sections are used more and more as primary framing components and as a secondary structural system. They are used as purlins and side rails or floor joist, and after that in the building envelops. Beams are not perfectly straight and are usually associated with geometric imperfections. Initial geometric imperfections can significantly influence the stability response of cold-formed steel members. This paper reports a numerical investigation concerning the effect of these imperfections on the behavior of the simply supported beams subjected to a uniform bending moment. The beam profile is cold formed sigma sections. Group of beams with different overall member slenderness ratios were studied. Several approaches have been utilized to model the geometric imperfections. First, the elastic buckling modes were considered as the imperfect beam shape. In this approach, the elastic buckling analysis was done first to get the elastic buckling modes. In the second approach, the imperfections were considered by assuming the beam bent in a half sine wave along its length. Finally, combination of these two approaches was considered. Results reveal that, the ultimate bending moments of beams with short and intermediate overall slenderness ratios are sensitive to the imperfect shape that comprise compression flange local buckling