Selection of parameters for advanced machining processes using firefly algorithm

AbstractAdvanced machining processes (AMPs) are widely utilized in industries for machining complex geometries and intricate profiles. In this paper, two significant processes such as electric discharge machining (EDM) and abrasive water jet machining (AWJM) are considered to get the optimum values of responses for the given range of process parameters. The firefly algorithm (FA) is attempted to the considered processes to obtain optimized parameters and the results obtained are compared with the results given by previous researchers. The variation of process parameters with respect to the responses are plotted to confirm the optimum results obtained using FA. In EDM process, the performance parameter “MRR” is increased from 159.70gm/min to 181.6723gm/min, while “Ra” and “REWR” are decreased from 6.21μm to 3.6767μm and 6.21% to 6.324×10−5% respectively. In AWJM process, the value of the “kerf” and “Ra” are decreased from 0.858mm to 0.3704mm and 5.41mm to 4.443mm respectively. In both the processes, the obtained results show a significant improvement in the responses