Lateral bearing capacity of rigid piles near clay slopes

AbstractAnalytical equations were derived to determine the undrained lateral bearing capacity of rigid piles in cohesive soil. Piles in level ground and piles placed at a distance from the crest of a slope were examined, taking account of the effect of the adhesion at the pile–soil interface. The derived analytical solutions were used to develop charts relating the lateral pile capacity to the pile length/diameter ratio, the pile–soil adhesion, the distance of the point of load application from the ground to the pile diameter ratio, the inclination of the slope and the distance of the pile from the crest of the slope to the pile diameter ratio. They were also used to derive a reduction factor which, when multiplied by the lateral bearing capacity for level ground, gives the bearing capacity of the same pile near a slope. In addition, a critical non-dimensional distance between the pile and the crest of the slope, at which the bearing capacity approaches that for a level ground, was determined. The bearing capacity charts obtained for level ground were compared to the classic Broms' charts and to others derived using several different lateral earth pressure distributions along the pile. Comparisons were also made between the results of the proposed method for piles near slopes and those obtained from charts based on upper bound calculations. Finally, the proposed new method was validated through a comparison with the results of a large number of pile load tests, in which a remarkable agreement was observed between the analytical results and the measurements