AbstractIn this paper, the stress-rupture tests of a low Re-containing single crystal alloy IC21 before and after thermal exposure at 1100°C for various periods of time were conducted under the test condition of 1100°C/137MPa, and the microstructure of the tested specimens was characterized by SEM and TEM. The experimental results showed that the stress rupture life of this alloy was over 150h after the standard heat treatment of 1320°C, 10h/AC+870, 32h/AC, however the stress rupture life decreased with the increase of exposure time due to the microstructure degradation. The TEM analysis revealed that the interface mismatch dislocation networks were well established. It was observed that these mismatch networks could form at 1100°C even aft...
The present study was aimed at determining the surface strain/stress state in an Ni-based single-cry...
The PER72® grade is used as a wrought engine turbine disk, which is a critical high temperature comp...
The effect of solution treatment and intermediate heat treatment on the microstructure and propertie...
AbstractIn this paper, the stress-rupture tests of a low Re-containing single crystal alloy IC21 bef...
The influence of long-term thermal exposure on microstructure evolution and tensile behavior of a ne...
The influence of service-induced degradation on residual life is very important for the safe service...
AbstractA nickel based single crystal superalloy with [001] orientation was prepared by the screw se...
The influences of different directional solidification processes, i.e., the high rate solidification...
Inconel 625 superalloy (IN625) was generally welded as the base metal to fabricate the rotors in ste...
International audienceThe PER72 (R) grade is used as a wrought engine turbine disk, which is a criti...
International audienceThe superalloy CMSX-4 was subjected to thermal cycling between 900-1050ºC and ...
The deformation and damage mechanisms arising during thermal-mechanical fatigue (TMF) of the single-...
The present study was aimed at determining the surface strain/stress state in an Ni-based single-cry...
The microstructure evolution and its influence on the mechanical properties are investigated in a ho...
The microstructure evolution and its influence on the mechanical properties are investigated in a ho...
The present study was aimed at determining the surface strain/stress state in an Ni-based single-cry...
The PER72® grade is used as a wrought engine turbine disk, which is a critical high temperature comp...
The effect of solution treatment and intermediate heat treatment on the microstructure and propertie...
AbstractIn this paper, the stress-rupture tests of a low Re-containing single crystal alloy IC21 bef...
The influence of long-term thermal exposure on microstructure evolution and tensile behavior of a ne...
The influence of service-induced degradation on residual life is very important for the safe service...
AbstractA nickel based single crystal superalloy with [001] orientation was prepared by the screw se...
The influences of different directional solidification processes, i.e., the high rate solidification...
Inconel 625 superalloy (IN625) was generally welded as the base metal to fabricate the rotors in ste...
International audienceThe PER72 (R) grade is used as a wrought engine turbine disk, which is a criti...
International audienceThe superalloy CMSX-4 was subjected to thermal cycling between 900-1050ºC and ...
The deformation and damage mechanisms arising during thermal-mechanical fatigue (TMF) of the single-...
The present study was aimed at determining the surface strain/stress state in an Ni-based single-cry...
The microstructure evolution and its influence on the mechanical properties are investigated in a ho...
The microstructure evolution and its influence on the mechanical properties are investigated in a ho...
The present study was aimed at determining the surface strain/stress state in an Ni-based single-cry...
The PER72® grade is used as a wrought engine turbine disk, which is a critical high temperature comp...
The effect of solution treatment and intermediate heat treatment on the microstructure and propertie...