Melt layer erosion during ELM-like heat loading on molybdenum as an alternative plasma-facing material

Abstract Transient events that occur during plasma instabilities in fusion reactors impart large heat fluxes onto the surrounding plasma-facing components (PFCs). Erosion and splashing of PFCs can contaminate the plasma and shorten material lifetime. Although tungsten is currently considered the most promising candidate material for future PFCs, concerns over the thermal shock performance during type-I ELMs (transient events expected in fusion devices) necessitate the study of other comparable materials. ELM-like heat loading was applied via a pulsed Nd:YAG millisecond laser on a pristine molybdenum (Mo) surface to measure surface melting and mass loss. One potential advantage of Mo is its higher specific heat of vaporization, which could lead to reduced particle emission. Imaging of the surface after loading revealed that complete surface melting began at 1.0 MJ m−2 (heat load parameter of 31.62 MJ m−2 s−1/2). Photon excitation also increased significantly above 1.0 MJ m−2, indicating possible phase change. At 1.4 MJ m−2 (44.27 MJ m−2 s−1/2), in situ mass loss measurements found an exponential increase in particle emission, indicating the presence of droplet formation and boiling. Direct comparisons of erosion during pulsed heat loading between PFC candidate materials will ensure that future fusion devices design components with optimal thermal strength