Ultrasonic-Assisted Cutting: A Beneficial Application for Temperature, Torque Reduction, and Cutting Ability Improvement in Deep Drilling of Al-6061

This paper presents an experimental study of the positive effects of vibration-assisted deep drilling of aluminum alloy Al-6061. The four most important evaluation criteria in drilling—machinability, workpiece temperature, torque, and material removal rate—were chosen to be investigated. Holes with a depth-to-diameter ratio of 13 were drilled by high speed steel (HSS) twist drill bits of 3 mm diameter, using both methods of conventional drilling (CD) and ultrasonic-assisted drilling (UAD). Three levels of axial force of 6 kgf, 9 kgf, and 12 kgf were kept constant for each pair of comparison experiments. It was found that workpiece temperature and torque not only changed from one drill to the other, but were also dependent on the hole depth being drilled. Comparisons were made in-pair between CD and UAD under the same axial force and at the same order of hole numbers. The result shows that the material removal rate with UAD was up to 3.5 times higher than that with CD and the average workpiece temperature and torque in UAD were reduced by 3.5 and 6 times, respectively. Moreover, tool life in UAD was observed to increase from 2.5 to 5 times, in terms of number of holes drilled, compared to that in CD