Experimental and Simulation Investigation on the Kinetic Energy Dissipation Rate of a Fixed Spray-Plate Sprinkler

Sprinkler irrigation is promoted due to its remarkable advantages in water conservation, but the high energy consumption limits its development in a situation of energy scarcity. In order to determine the energy consumption of a fixed spray-plate sprinkler (FSPS), its discharge and initial trajectory velocity were investigated using a particle image velocimetry (PIV) technique and computational fluid dynamics (CFD) analyses. A nozzle diameter of 4.76 mm was used under windless conditions. Overall, good agreement between simulation results and experimental values was obtained. On the premise that the simulation method produced high accuracy, a series of simulations was performed with different nozzle diameters. The water distribution pattern, stream trajectory velocity and kinetic energy dissipation were analyzed. The results show that the jet produced at the nozzle is split by grooves after it hits the plate, with separation occurring earlier with decreasing nozzle diameter. The area of the flow cross-section of the outlet is mainly influenced by nozzle diameter rather than working pressure. The initial trajectory velocity of the grooves increases logarithmically with increasing working pressure. A high working pressure may not cause large kinetic energy dissipation. The dissipation rate of the FSPS ranged from 28.01–50.97%, i.e., a large kinetic energy rate was observed. To reduce this energy dissipation and improve water use efficiency, the structure of the FSPS should be optimized in further research