WOODY NECROMASS STOCK IN MIXED OMBROPHILOUS FOREST USING DIFFERENT SAMPLING METHODS

The objective of this study was to quantify the necromass stock in a Mixed Ombrophilous Forest (MOF) fragment in the National Forest of Irati, State of Paraná, Brazil. Two sampling methods were tested: FA1, consisting of a fixed area (FA) approach with sample units measuring 2,500 m2 (50 m × 50 m); and FA2, consisting of fixed area sampling units measuring 500 m2 (10 m × 50 m) and line intercept sampling (LI) using 50 m lines. Data were collected on permanent sample plots installed in the area, consisting of 25 square blocks of 1 ha. Fallen dead wood pieces with a diameter = 10 cm were used in the analysis. The dead wood was classified into three degrees of decomposition, and masses were calculated as the corresponding density at each class. The tested sampling methods were evaluated using coefficient of variation and relative sampling error, and the nonparametric Kruskal-Wallis test was used to compare the results between the methods. Volume size of fallen dead wood did not statistically differ between the methods, but variation in necromass volume was lower in the FA1 method, whereas the FA2 method had a smaller sampling error. Overall sampling error ranged from 23.4-27.92%; lowering the sampling error to 15% would require a high sampling intensity (FA1: 42 area units a.u., FA2: 99 a.u., and LI: 236 a.u.). Total necromass weights amounted to 4.67 Mg.ha-1 (FA1); 5.16 Mg.ha-1 (FA2) and 4.58 Mg.ha-1 (IL), and carbon stock estimates were 2.00 Mg.C.ha-1 (FA1); 2.20 Mg.C.ha-1 (FA2) and 1.96 Mg.C.ha-1 (IL)