An aqueous cathodic delamination route towards high quality graphene flakes for oil sorption and electrochemical charge storage applications

The electrochemical exfoliation of graphite in aqueous medium stands out as an attractive, scalable approach for the production of graphenes for different applications, due to its simplicity, cost-effectiveness and environmental friendliness. In particular, cathodic exfoliation in water should allow access to high quality, non-oxidized graphene flakes, as it avoids the intrinsic oxidizing conditions that typically plague the anodic route, but this possibility has been limited by a poor intercalation ability of aqueous cations. Here, we demonstrate that with a proper choice of starting graphite and electrolyte, high quality graphene flakes can be obtained in substantial yields via cathodic delamination in water. Graphites having some pre-expanded edges and interlayer voids (e.g., graphite foil) were found to be critical for a successful exfoliation. Large differences in the efficiency of a range of aqueous quaternary ammonium-based electrolytes were observed, quantitatively compared and rationalized on the basis of their chemical structure. Graphene yields up to 40–50 wt% were attained with the most efficient cations (tetrapropylammonium and hexyltrimethylammonium). Hydrophobic sponges made up of cathodic graphene-coated melamine foam exhibited a notable capacity towards the sorption of oils and organic solvents from water with good re-usability. Hybrids comprised of cathodically exfoliated graphite and a small amount of vertically oriented cobalt oxide nanosheets displayed good electrochemical charge storage behavior. Overall, the ability to access graphene flakes in considerable yields by the aqueous cathodic route disclosed here should raise the prospects of cathodic exfoliation as a competitive method for the industrial manufacturing of high quality graphene for practical applications.Funding by the Spanish Ministerio de Economía y Competitividad (MINECO) and the European Regional Development Fund (ERDF) through project MAT2015-69844-R and by the Spanish Ministerio de Ciencia, Innovación y Universidades and ERDF through project RTI2018-100832-B-I00 is gratefully acknowledged. Partial funding by Plan de Ciencia, Tecnología e Innovación (PCTI) 2013-2017 del Principado de Asturias and the ERDF through project IDI/2018/000233 is also aknowledged. S.G-D. and J.M.M. are grateful to MINECO and the Spanish Ministerio de Educación, Cultura y Deporte (MECD), respectively, for their pre-doctoral contracts (BES/2016 077830 and FPU14/00792, respectively).Peer reviewe