A General Weibull Model For Reliability Analysis Under Different Failure Criteria Application on Anisotropic conductive adhesive joining technology

In this paper a generic four-parameter model has been developed and applied to the ACA flip-chip joining technology for electronics packaging applications. The model can also be used to predict any minimum failure cycles if the maximum acceptable failure criterion (in this case, a preset electrical resistance value) is set. The original reliability testing from which the test data was obtained was carried out on Flip-Chip anisotropically conductive adhesive joints on an FR-4 substrate. In the study, nine types of anisotropic conductive adhesive (ACA) and one non-conductive film (NCF) were used. In total, nearly one thousand single joints were subjected to reliability tests in terms of temperature cycling between -40\ub0C and 125\ub0C with a dwell time of 15 minutes and a ramp rate of 110\ub0C/min. The reliability was characterized by single contact resistance measured using the four-probe method during temperature cycling testing up to 3000 cycles. A single Weibull model is used for two failure definitions defined as larger than 50mΩ and larger than 100 mΩ respectively using the in-situ electrical resistance measurement technique. The failure criteria are incorporated into this Weibull model. This study shows the flexibility and usefulness of Weibull distribution in this type of applications