Cooling rate effect on Young\u27s modulus and hardness of a Zr-based metallic glass

It is known that cooling rate can affect the atomic structure and thus may possibly affect the mechanical properties of metallic glasses (MGs). In spite of the considerable efforts on the cooling rate, its effect on the mechanical properties is controversial at the present time. In this study, we present a micromechanical study of the cooling-rate effect on Young\u27s moduli and hardness of the cast bulks and melt-spun ribbons for a Zr(55)Pd(10)Cu(20)Ni(5)Al(10) metallic glass. Using the classic nanoindentation method, the Young\u27s moduli of the ribbon samples obtained at higher cooling rates were measured which appeared to be much lower than those of the bulk samples. However, through further experiments on slice samples cut from the as-cast bulks and finite-element (FE) analyses, we have clearly demonstrated that the measured difference in elastic moduli was mainly caused by the sample thickness effect in nanoindentation tests. To overcome such a confounding effect, microcompression experiments were performed on the as-cast and as-spun MG samples, respectively. Being consistent with the findings from nanoindentation, the microcompression results showed that the cooling rate, as ranging from similar to 10(2) to similar to 10(6) K/s, essentially has no influence on the Young\u27s modulus and hardness of the metallic glasses. (C) 2010 Elsevier B.V. All rights reserved