Improvements of fill factor in solar cells based on blends of polyfluorene copolymers as electron donors

The photovoltaic characteristics of solar cells based on alternating polyfluorene copolymers, poly(2,7-(9,9-dioctyl-fluorene)-alt-5,5-(4\u27,7\u27-di-2-thienyl-2\u27,1\u27,3\u27-benzothiadiazole)) (APFO-3), and poly(2,7-(9,9-didodecyl-fluorene)-alt-5,5-(4\u27,7\u27-di-2-thienyl-2\u27,1\u27,3\u27-benzothiadiazole)) (APFO-4), blended with an electron acceptor fullerene mol. [6,6]-phenyl-C61-butyric acid Me ester (PCBM), have been investigated and compared. The two copolymers have the same arom. backbone structure but differ by the length of their alkyl side chain. The overall photovoltaic performance of the solar cells is comparable irresp. of the copolymer used in the active layer. However, the fill factor (FF) values of the devices are strongly affected by the copolymer type. Higher FF values were realized in solar cells with APFO-4 (with longer alkyl side chain)/PCBM bulk heterojunction active layer. On the other hand, devices with blends of APFO-3/APFO-4/PCBM were found to render fill factor values that are intermediate between the values obtained in solar cells with APFO-3/PCBM and APFO-4/PCBM active film. Upon using APFO-3/APFO-4 blends as electron donors, the cell efficiency can be enhanced by about 16% as compared to cells with either APFO-3 or APFO-4. The transport of holes in each polymer obeys the model of hopping transport in disordered media. However, the degree of energetic barrier against hopping was found to be larger in APFO-3. The tuning of the photovoltaic parameters will be discussed based on studies of hole transport in the pure polymer films, and morphol. of blend layers. The effect of bipolar transport in PCBM will also be discussed. [on SciFinder (R)