Mechanical Characterization of a Nickel-based Superalloy Repaired using MicroPlasma and ESD Technology

In this work, the possibility using two different technologies to repair industrial flat components made of Waspaloy superalloy was investigated. Specimens present a V notch in the central zone of the gage length, which has been refilled by MicroPlasma and Electro Spark Deposition in order to recover the original thickness of the material. These specimens have been used for a complete mechanical characterization, carrying out static, low-cycle fatigue and creep tests. Finally, results have been compared to base material. Static and low-cycle fatigue test have been carried out at Room Temperature and 538 °C, while creep test considered the temperature of 704 °C. Results of uniaxial tensile tests showed that the two repair process have a different effect on the mechanical properties. While MicroPlasma produced a reduced yield stress and tensile strength but a good performance whit respect to the elongation to failure, Electro Spark Deposition assured a better mechanical strength but a reduced elongation to failure. Low-cycle fatigue properties have been determined carrying out tests at different temperature (Room Temperature and 538 °C). Repaired material showed lower fatigue strength and an increase of the data scatter, especially ESD at 538 °C. Finally, creep test carried out on a limited number of specimens allowed establishing some changes about the creep rate and time to failure. MP behaviour was more similar to base material, while ESD show the presence of a marked tertiary creep