Oxidation and Alpha–Case Phenomena in Titanium Alloys used in Aerospace Industry: Ti–6Al–2Sn–4Zr–2Mo and Ti–6Al–4V

Titanium and its alloys are attractive engineering materials in aerospace industry because of their outstanding mechanical properties such as high specific strength and excellent corrosion resistance. Ti–6Al–2Sn–4Zr–2Mo (Ti–6242) and Ti–6Al–4V (Ti–64) are two alloys commonly used for manufacturing components in jet engines, such as fan blades, disks, wheels and sections of the compressor where the maximum temperature is in the range of 300–450 °C. At temperatures above 500 °C and in oxygen containing environments, these alloys are oxidizing rapidly. Oxidation normally involves formation of an oxide scale on top of the metal and a hard and brittle oxygen enriched layer beneath the scale which is known as “alpha–case”. The alpha–case layer has a detrimental effect on important mechanical properties such as ductility, fracture toughness and especially the fatigue life when an engine component is subjected to dynamic loading. In order to increase the understanding of the oxidation and alpha–case phenomena, the behaviour of these two alloys after long time exposure in air at elevated temperature has been investigated. Heat treatments were performed on Ti–6242 and Ti–64 alloys in ambient air at 500, 593 and 700 °C for times up to 500 hours. The oxide scale and the alpha–case layer were analysed, characterized and compared for both alloys. It was found that the oxide scale and alpha–case thickness are functions of temperature and time. Faster and more complex oxidation kinetics was noted in Ti–64, whereas in Ti–6242 the oxidation kinetics was found moderate at all tested temperatures and times. Discrepancies in the oxidation kinetics are believed to be because of the differences in the chemical composition and the microstructure of the two alloys. In addition, different morphology of the oxide scales was observed after 500 hours exposure time at 700 °C. The thickness of the alpha–case layer was measured using conventional metallographic and microscopic techniques. It was found that in both alloys the alpha–case growth obeys parabolic law with respect to time at all three tested temperatures. In addition, the diffusion coefficients and the activation energy of oxygen diffusion were estimated in the temperature range of 500–700 °C for the two alloys. Electron probe micro analyser (EPMA) was used to measure the oxygen concentration along the thickness of the alpha–case layer. It was found that the oxygen concentration decreases along the alpha–case layer. The oxygen concentration profiles were used to estimate the alpha–case thicknesses and it was found good agreement with the optically measured values for almost all investigated temperatures and times. Only at 700 °C in the time interval 300–500 hours in Ti–6242 a difference between the results from the two methods was found. Moreover, the EPMA concentration profiles of the main α and β alloying elements, before and after heat treatment at 700 °C for 500 hours, revealed microstructural changes and an increase of the α–phase volume fraction in the two investigated alloys.Godkänd; 2014; 20140507 (birsef); Nedanstående person kommer att hålla licentiatseminarium för avläggande av teknologie licentiatexamen. Namn: Birhan Sefer Ämne: Materialteknik/Engineering Materials Uppsats: Oxidation and Alpha-Case Phenomena in Titanium Alloys used in Aerospace Industry: Ti-6Al-2Sn-4Zr-2Mo and Ti-6Al-4V Examinator: Biträdande professor Marta-Lena Antti, Institutionen för teknikvetenskap och matematik, Luleå tekniska universitet Diskutant: Associate Professor Andreas Kaiser, Technical University of Denmark, Roskilde, Denmark Tid: Torsdag den 12 juni 2014 kl 13.00 Plats: E243, Luleå tekniska universite