Evaluation of Foundation Settlement under Various Added Loads in Different Locations of Iraq Using Finite Element

Settlement is an important criterion in the design of the foundations. It is classifying into immedi-ate (or elastic) settlement and consolidated settlement (primary and secondary). The factors that affect the shallow foundation settlement are the applied loads, soil stiffness, and geometric shape of foundation. Calculations of settlement depend on the parameters of soil which can be obtained from field and laboratory tests. Field and laboratory tests were conducted for twenty three sites in three different regions in Iraq (Mosul, Baghdad, and Basrah). In this research, field and laboratory tests results adopted for two sites from each region depended on the maximum and minimum bearing capacity values. Settlement for each site was calculated using numerical (mathematical) calculations and PLAXIS software under different added loads. The results of settlements beneath the foundation were competing for the sites with maximum value of bearing capacity in Mosul; Baghdad and Basrah. Also, the comparison conducted for sites of minimum bearing capacity value and the results showed different settlement values of each site. The change of settlement values under different loads was linearly in the six sites using numerical (mathematical) calculations. While, the settlement values obtained from PLAXIS software for sites with maximum bearing ca- pacity value showed that Mosul site had the highest value due to the type of soil layers and the dif- ference models of soil used in the software. Basrah site had a settlement value higher than Bagh- dad site due to the soil layers of sand type only. PLAXIS results for sites with minimum bearing capacity showed that for Basrah site the soil went to failure. While, the settlement values for Mosul and Baghdad sites were close to each other due to have nearly same soil layers. Therefore, high rise buildings could not be used in some sites. Also, soil in some locations and under some added loads needed to be improved before the implementation of any constructions.Validerad; 2016; Nivå 1; 20160512 (nadhir