Effects of Fly Ash on the properties of Alkali Activated Slag Concrete

This master thesis presents the effects of fly ash on the properties of alkali activated slag concrete, commonly referred as Geopolymer concrete (GPC). Cement manufacturer are major producers of CO2 which negatively affects the environment. Due to the increased construction activities and environmental concern, it is necessary to introduce alternative and eco-friendly binders for concrete. Slag and fly ash based concrete, which is by-product from industrial waste, is probably the best replacement for OPC concrete due to less or nil environmental issue. Most of the researchers have already concluded that slag and fly ash can be used as binders in concrete by activating them with alkali activator solution (e.g. by sodium silicate or sodium carbonate). In the present work concretes were produced by varying the proportion of slag to fly ash (40:60, 50:50, 60:40 & 80:20); amount of alkali activators (5, 10 & 14) and chemical modulus of sodium silicate (Ms) (0.25, 0.5 & 1). Setting times and compressive strength values were evaluated. Results showed that decrease in fly ash content irrespective of % of alkali activators and alkali modulus (Ms), the compressive strength was increasing and setting time was getting shorter. The produced concretes showed increasing compressive strength with increase in % of alkali activator for Ms 0.5 and 1, while for Ms=0.25 the strength was decreasing with increase in % of alkali activators. From this it can be concluded that, Ms=0.5 was the optimum point below which the reaction got slower. Based on the initial investigations, mix S8:F2-SS10(1) and S8:F2-SS10(0.5) showed most promising results in terms of fresh and hardened concrete properties and were easy to handle. Consequently, the above mentioned mixture was chosen to be studied in more detail. The experimental program for these mixes included determination of slump flow, compressive strength (7, 14, 28 days) and shrinkage (drying and autogenous). The results shows that, strength increased with time and comparatively mix with Ms=0.5 showed higher compressive strength than mix with Ms=1, due to higher alkalinity of the pore solution. Mix with Ms=1 showed higher drying shrinkage compared to mix with Ms=0.5, which was explained by higher alkalinity of the solutions (Ms=0.5) leading to rapid formation of aluminosilicate gel. Autogenous shrinkage appeared to be higher for mix with Ms=0.5. This was associated with lower modulus which leads to densification of concrete microstructure at early ages. Pore diameter decrease and the water trapped in the pores exerted increasing tensile stress resulting for higher autogenous shrinkage