Using MODIS and GLAS Data to Develop Timber Volume Estimates in Central Siberia

The boreal forest is the Earth's largest terrestrial biome, covering some 12 million km2 and accounting for about one third of this planet's total forest area. Mapping of boreal forest's type, structure parameters and biomass are critical for understanding the boreal forest's significance in the carbon cycle, its response to and impact on global climate change. Ground based forest inventories, have much uncertainty in the inventory data, particularly in remote areas of Siberia where sampling is sparse and/or lacking. In addition, many of the forest inventories that do exist for Siberia are now a decade or more old. Thus, available forest inventories fail to capture the current conditions. Changes in forest structure in a particular forest-type and region can change significantly due to changing environment conditions, and natural and anthropogenic disturbance. Remote sensing methods can potentially overcome these problems. Multispectral sensors can be used to provide vegetation cover maps that show a timely and accurate geographic distribution of vegetation types rather than decade old ground based maps. Lidar sensors can be used to directly obtain measurements that can be used to derive critical forest structure information (e.g., height, density, and volume). These in turn can used to estimate biomass components using allometric equations without having to use out dated forest inventory. Finally, remote sensing data is ideally suited to provide a sampling basis for a rigorous statistical estimate of the variance and error bound on forest structure measures. In this study, new remote sensing methods were applied to develop estimates timber volume using NASA's MODerate resolution Imaging Spectroradiometer (MODIS) and unique waveform data of the geoscience laser altimeter system (GLAS) for a 10 deg x 10 deg area in central Siberia. Using MODIS and GLAS data, maps were produced for cover type and timber volume for 2003, and a realistic variance (error bound) for timber volume was calculated for the study area. In this 'study we used only GLAS footprints that had a slope value of less than 10 deg. This was done to avoid large errors due to the effect of slope on the GLAS models. The method requires the integration of new remote sensing methods with available ground studies of forest timber volume conducted in Russian forests. The results were compared to traditional ground forest inventory methods reported in the literature and to ground truth collected in the study area