FEM analysis of a Mode III fracture mechanics test specimens for cohesive law determination of fibre composite

Delamination is one of the common failure types in the fiber composites. The trailing edge in the wind turbine blades, for example, is one of the structural components where the delamination is driven by mode III under predominantly flapwise loading. There has been an extensive effort in developing test procedures and test specimens for determination of the delamination toughness in mode I and mode II delamination while the mode III is neglected due to its complexity, on the one hand, and the lack of a reliable test procedure and numerical model for the mode III delamination toughness testing on the other hand. Therefore, the cur- rent project aims for developing an experimental test specimen capable of extracting cohesive laws using the J integral approach. To this end, the FEM is utilized for the analyses of various parameters.Delamination can be modeled using Progressive Failure Analysis where the crack initia- tion and crack evolution are studied. The present thesis covers both aspects of the Progressive Failure Analysis in the unidirectional fiber composites. Before starting the mode III, mode I and II test specimens are analyzed to establish requirements for proper three-dimensional simulation. The reliable numerical model from this step is the fundamental model for the mode III delamination analysis. In the first part of the project, the Double Cantilever Beam cross-section is optimized to give the pure mode III. LEFM is invoked for the analyses of this section (Small Fracture Process Zone). The results have shown that the pure mode III cannot be accomplished and there always exists an induced coupling mode II under anti-plane load- ing. Furthermore, the results suggest higher mesh density is required at the free surface to further investigate the 1/√r-singularity at this location.The second part of the thesis covers the Cohesive Zone Modeling (Large Fracture Process Zone) whereby the crack evolution is simulated by the cohesive elements. The implemented cohesive law is validated by the J integral. The bilinear cohesive law has been successful in simulating the crack extension for Large-Scale Bridging condition. The traction-separation law has been validated through the resistance curve generated by the FEM and derivation of the resistance w.r.t the tangential end-opening.The commercial code, ABAQUS, is utilized in this study for the Finite Element Analyses.European Wind Energy Masters (EWEM