DIRECT NUMERICAL SIMULATION OF FLUIDIZED BED WITH IMMERSED BOUNDARY METHOD

The applicability of the immersed boundary (IB) method, which is one of direct numerical simulations (DNS) for multiphase flow analyses, has been examined to simulate a fluidized bed. The volumetric-force type IB method developed by Kajishima et al. (2001) has been applied in the present work. While particle-fluid interaction force is calculated with the surface integral of fluid stress at the interface between particle and fluid in the standard IB method, the volume integral of interaction force is used in the volumetric-force type IB method. In order to validate the present simulation code, drag force and lift force firstly were calculated with IB method. Then calculated drag coefficients were compared with values estimated with Schiller-Nauman and Ergun equations, while calculated lift coefficients were compared with the previous simulated results. The difference of drag was within approximately 1% except in the range of low Reynolds number. Thus, the accuracy of the present simulation code was confirmed. Next, simulation of fluidized bed was carried out. Since DNS requires a large computer capacity, only 400 particles were used. The particle is 1.0mm in diameter and 2650kg/m3 in density. From the simulated results, concentrated upward stream lines from the bottom wall were observed in some regions. This inhomogeneous flow would be attributed to particulate structure