Human-robot cooperation control based on a dynamic model of an upper limb exoskeleton for human power amplification

In this paper, we propose a human-robot cooperation controller for the motion of the upper limb exoskeleton. The system permits three degrees of freedom using an electrical actuator that is mainly controlled by force sensor signals. These signals are used to generate the torque required to drive the exoskeleton. However, singularities exist when the force signals in the Cartesian coordinate system are transformed into torques in the joint coordinate system. Therefore, we apply the damped least squares method. When handling a load, torque compensation is required about its mass. Therefore, we installed a force sensor at the point of the robot's end-effector. It measures the forces between the exoskeleton and the load. Then, these forces are used to compensate within a static model for handling loads. We performed control stability and load handling experiments to verify the effectiveness of the controller. Via these, we confirmed the effectiveness of the proposed controller. (C) 2014 Elsevier Ltd. All rights reserved.This research was partially supported by the robot R&D program of the Ministry of Knowledge and Economy (MKE), Korea. [No. 10035431, Development of wearable robot for industrial labor support] and partially supported by the Ministry of Knowledge Economy (MKE, Korea), under the Advanced Robot Manipulation Research Center support program supervised by National IT Industry Promotion Agency (NIPA), NIPA-2013-H1502-13-1001