DSP based induction motor torque and parameter identification

This material is presented to ensure timely dissemination of scholarly and technical work. Copyright and all rights therein are retained by authors or by other copyright holders. All persons copying this information are expected to adhere to the terms and constraints invoked by each author's copyright. In most cases, these works may not be reposted without the explicit permission of the copyright holder.---- Copyright IEEE. Personal use of this material is permitted. However, permission to reprint/republish this material for advertising or promotional purposes or for creating new collective works for resale or redistribution to servers or lists, or to reuse any copyrighted component of this work in other works must be obtained from the IEEE.A practical induction motor torque and parameter measurement scheme is proposed without using any mechanical sensors. The torque and parameter calciulation is performed by a digital signal processor (DSP) based on measured motor terminal waveforms. Since the motor parameters are required for torque calculation, a novel scheme is developed for parameter identification. The motor parameters can be extracted from the measured motor current and motor voltage when the motor, fed by inverters, AC voltage controllers or other equipment, is started under no load conditions. The propcsed torque measurement scheme has the features of wide bandwidth and no need for mechanical sensors. Simulation and experimental results on a 5hp induction machine driven under various operating conditions are also given for verification