Control of Three-Phase, Four-Wire PWM Rectifier

This paper presents the analysis, design, and control of a four-wire rectifier system using split-capacitor topology. The proposed controller does not require any complex transformation or input voltage sensing. A detailed analysis of the distortions in the line and the neutral currents is presented. It is shown that the single-carrier-based, conventional sine-triangle PWM (CSPWM) scheme results in a peak-to-peak neutral current ripple, which is greater than the peak-to-peak ripple of any of the line currents. Also, for the same operating condition, the distortions in the line and the neutral currents increase considerably, when a three-limb boost inductor is used instead of three single-phase inductors. A three-carrier-based SPWM scheme is proposed in this paper. Compared to CSPWM, the proposed scheme significantly reduces the neutral current ripple when three single-phase inductors are used, and reduces both line and neutral current ripples when a three-limb inductor is used. The control scheme is verified through Matlab simulation. It is implemented on an field-programmable gate-array (FPGA)-based digital controller and tested on a prototype. Simulation and experimental results are presented