Multiaxial fatigue strength of common structural steel and the response of some estimation methods

This paper describes the multiaxial fatigue strengths obtained from a series of load-controlled fatigue experiments in the high-cycle fatigue domain. The experiments were carried out on unnotched specimens manufactured from common structural steel CSN 41 1523. Various load combinations were induced, including some rare combinations, e.g. a combination of pressurizing and plane bending. The stress states on the inner surface and also on the outer surface of hollow specimens are therefore evaluated in the subsequent fatigue strength analyses. The goal of the paper is to derive a new solution for estimating multiaxial fatigue strength that will better conform to the described experiments than the Manson-McKnight method, but which will keep its simplicity of calculation. Our final proposal - the MMP criterion - is compared with various versions of the Manson-McKnight method, and also with four multiaxial methods (Dang Van, Liu-Zenner, Crossland and Papuga PCr). The results for the MMP criterion are quite motivating, thanks to the simplicity of the computational algorithm and the quality of the prediction output, which is comparable with the output of the evaluated multiaxial methods. However, the set of experiments described here is not large enough either for more thorough statistical analyses of prediction quality, or for more enhanced improvement of the MMP criterion, which would include e.g. the effect of non-proportional loading.Web of Science104422