Improvement of Serviceability and Strength of Textile Reinforced Concrete by using Short Fibres

Nowadays, thin-walled load bearing structures can be realised using textile reinforced concrete (BRAMESHUBER and RILEM TC 201-TRC [1]). The required tensile strength is achieved by embedding several layers of textile. By means of the laminating technique the number of textile layers that can be included into the concrete could be increased. To further increase the first crack stress and the ductility as well as to optimize the crack development, fine grained concrete mixes with short fibres can be used. By a schematic stress-strain curve the demands on short fibres are defined. Within the scope of this study, short fibres made of glass, carbon, aramid and polyvinyl alcohol are investigated in terms of their ability to fit these requirements. On the basis of these results, the development of hybrid fibre mixes to achieve the best mechanical properties is described. Additionally, a conventional FRC with one fibre type is introduced. Finally, the fresh and hardened concrete properties as well as the influence of short fibres on the load bearing behaviour of textile reinforced concrete are discussed