Effects of Vegetation Stems on Hydraulics of Overland Flow Under Varying Water Discharges

Vegetation plays an important role in soil erosion control, but few studies have been performed to quantify the effects of vegetation stems on hydraulics of overland flow. Laboratory flume experiments were conducted to investigate the potential effects of vegetation stems on Reynolds number, Froude number, flow velocity and hydraulic resistance of silt-laden overland flow. Cylinders with diameter D of 2·0, 3·2 and 4·0 × 10 2 m were glued onto the flume bed to simulate the vegetation stems, and a bare slope was used as control. The flow discharge varied from 0·5 to 1·5 × 10 3 m3 s 1 and slope gradient was 9°. Results showed that Reynolds number on vegetated slope was significantly higher than that on bare slope because of the effect of vegetation stems on effective flow width. All the flows were supercritical flow, but Froude number decreased as D increased, implying a decrease in runoff ability to carry sediment. The mean flow velocity also decreased with D,while the velocity profile became steeper, and no significant differences were found in surface flow velocities among longitudinal sections on all slopes. Darcy–Weisbach friction coefficient increased with D, implying that the energy consumption of overland flow on hydraulic resistance increased. Reynolds number was not a unique predictor of hydraulic roughness on vegetated slopes. The total resistance on vegetated slopes was partitioned into grain resistance and vegetation resistance, and vegetation resistance accounted for almost 80% of the total resistance and was the dominant roughness element. Further studies are needed to extend and apply the insights obtained under controlled conditions to actual overland flow conditions.