Forming Behavior of Manganese-Boron Steel 22MnB5 while Cooling according to its Microstructural Development

The press hardening belongs to state-of-the-art technology at sheet metal forming to gain high strength and crash resistant parts in automotive industry. This process could establish due to its cost- and esourceefficiency. According to ongoing developments on direct press hardening processes it is necessary to describe and understand the thermo-mechanical treatment of 22MnB5. Therefore the flow behavior and phase transformation during cooling with simultaneous forming is investigated. The experimental process considers industrial parameters in order to get industry-oriented results. In deep drawing processes the sheet metal is roped into the draw die and bended around the die edge. Thereby sheets perform different stages of compressive and tensile strain at the die oriented side and the punch oriented side of the sheet. There are different stages and values of stress and strain according to several layers of the sheet over its cross-section. The values of stress, strain and forming rate were FEcalculated for industry-relevant bending radii and sheet thicknesses of manganese-boron steel 22MnB5. According to the calculations different cooling and forming strategies were performed by dilatometric tests. The forming behavior is described by the microstructural development with regard to the cooling rate and temperature. Beside the influence of austenite forming on the phase transformation and mechanical properties is considered. A prospective view is given to illustrate ongoing examinations under compressive and combined tensional and compressive forces