Flame attachment and kinetics studies of laminar coflow CO/H2 diffusion flames burning in O2/H2O

In this study, experimental and numerical investigations were conducted to study the attachment and oxidation process of laminar CO/H2 diffusion flames burning in coflow O2/H2O at 1 atm with an inlet temperature of 400\u202fK for both the fuel and oxidizer streams. The effects of fuel composition were investigated by considering a wide range of CO/H2 mole ratio from 95%CO\u20135%H2 to 5%CO\u201395%H2 and also pure H2. The oxidizer has a fixed composition of 75%H2O\u201325%O2. The measured flame heights determined by OH*-chemiluminescence images were used to validate the flame model adopted in this work. Through numerical simulations using a two-dimensional flame code with the preheating effect, detailed reaction mechanism, and detailed thermal and transport properties, the details of flame attachment and flame structure were obtained and analysed. Although both CO and H2 diffuse over the burner rim and move upstream into the oxidizer stream, the attachment point of a H2-rich syngas flame is further upstream below the burner exit than that of a CO-rich flame. This is attributed to the high reactivity of H2 through reaction OH\u202f+\u202fH2\u202f=\u202fH\u202f+\u202fH2O and the high diffusivity of H2. Reaction pathways for syngas burning in the oxidizer of O2/H2O based on a detailed kinetics analysis were revealed, not only inside the fuel tube and above the fuel exit, but also near the flame sheet and in the flame attachment zone. Significant consumption of H2O was observed in the flame core due to the reverse reaction of OH\u202f+\u202fH2\u202f=\u202fH\u202f+\u202fH2O which shifts to proceed forward outside the flame in the radial direction also at higher streamwise locations if H2 in the fuel flow is rich, oxidizing unburned H2 to H2O.Peer reviewed: YesNRC publication: Ye