Optimization of Graphite Morphology in Mottled Nihard Cast Irons Inoculated with Feb and Manufactured by Centrifugal Casting

The present research was focused on the identification of manufacturing factors that have an active influence on the graphite phase formation in Nihard cast irons inoculated with FeB, constituting the outer layer of duplex work rolls. These rolls are used in the finishing stands of hot-strip steel mills where the following are desired: (a) between 2.5 and 4 vol % of graphite; (b) homogeneous graphite distribution across the layer section; and, (c) a reasonable high number of graphite particles across the layer. The research methodology that followed consisted of the application of a saturated design of experiments (DOE), with seven factors, eight experiments, and resolution III. The analyzed responses obtained by quantitative metallographic techniques were: the volume fraction of graphite, Vv; the number of counts per unit area of graphite, NA; and the graphite morphology across the layer thickness. Increasing the addition of FeB from 6 to 10 kg/T reduced the graphite volume fraction and the count number, but had no influence on its morphology. However, an increase of the liquidus temperature from 1225–1230 to 1250–1255 °C, and an increase in the amount of SiCaMn added to the ladle from 0.3 to 0.6 kg/T produced the desired compact graphite morphology