Long-wave infrared digital holography for the qualification of large space reflectors

Deformation metrology of complex and large space reflectors is a recurrent problem addressed by ESA. The challenging tasks of on-ground qualification and verification testing are to achieve the required accuracy in the measurement of these reflectors deformation and to verify their performance under simulated space conditions (vacuum, low temperature). A long-wave infrared digital holographic interferometer for the verification and validation of this type of reflector in a space environment is presented. It has been developed to fill the gap between holography/interferometry techniques in the visible wavelengths and methods based on structured light illumination like videogrammetry, stereocorrelation, and fringe/pattern projection. The former provide a good measurement uncertainty but the displacements are often too large to be measured and they require a very stable environment, while the latter provide large measurement range but with higher measurement uncertainty. The new instrument is based on digital holography and uses a CO2 lasers emitting at 10.6 µm combined with a commercial thermographic camera. A diffuser is illuminated by the laser beam, producing a speckle wavefront which is observed after reflection on the reflector surface. This reflected speckle wavefront behaves exactly as if the reflector was a diffusive surface, producing its own speckle, allowing the measurement of its deformation. The advantage of this configuration compared to a classical interferometer working at 10.6 µm, is that it requires no specific optics such as a null lens (in the case of parabola) or expensive illumination/collection optics (in the case of ellipse). The metrological certification of the system was performed in the laboratory by measuring the tilts of a 1.1 meter diameter parabolic reflector. The displacements are measured in parallel with a Doppler effect interferometer and the measurement uncertainty is estimated. The technique has been certified during a thermal-vacuum test. The deformation of the parabolic reflector is measured for a temperature variation from 288 K down to 113 K. The results are compared to previous results obtained on the same reflector with a high spatial resolution infrared interferometer, also developed at CSL.SCOPUS: cp.p