Gypsum deposits associated with the Whitehill Formation (Ecca Group) in the Steytlerville-Jansenville Area, Southern Karoo, South Africa

The Steyterville-Jansenville gypsum field is one of South Africa’s smaller deposits, yet plays host to several gypsum mines, both past and present. This study aims to deconstruct the processes involved in the precipitation of various quantities and grades of gypsum in the lower Ecca Group of the Karoo Supergroup. The calcium and sulphate ions required to form the gypsum mineral (CaSO4•2H2O) are derived from the mid- to lower-shale of the Whitehill Formation, which is carbonate- and pyrite-rich. Gypsum formation is dependent on the availability of pyrite as opposed to calcite, which is in abundance throughout the 30m thick, Early Ufimian (late Permian) Whitehill Formation. Weathered shale, which has been folded and faulted, forms the host environment in which gypsum has precipitated. Folding of the shale occurs as a series of large- and medium-scale anticlines and synclines that strike east to west. These structures, which formed during the Cape Orogeny indicate that stresses were exerted from the south-southwest towards the north-northeast. Folded calcite veins surrounded by amorphous pyrite, observed in thin section suggest that pyrite and calcite were precipitated together prior to a deformation event. Oxidation of pyrite following these deformation events results in the concentration of sulphides within the hinge zones of the folds (weakest zone) and this is where the larger gypsum deposits are found at the surface. Carbonate concretions in the Whitehill Formation up to 5m in length and 3m in width are common in the study area, and suggest a relationship with the deposition of the shale whereby calcium-rich nuclei grew in a concentric fashion during a non-depositional hiatus period. This period is also associated with a higher concentration of pyrite and could explain the occurrence of concretions together with adjacent gypsum-rich shale. Pyrite framboids observed under the Scanning Electron Microscope (SEM) provide evidence to suggest concentric growth of initially deposited microcrystals including nucleation and growth of nodules and concretions observed within the Whitehill Formation. Prerequisites for gypsum formation also include restricted drainage such as a pan, a clay layer in the drainage area and an arid climate where evaporation exceeds precipitation. The preferred surface conditions for gypsum formation would be low-lying areas which are surrounded by gently-sloping topography promoting the concentration of aqueous solutions in a calcite- and pyrite-rich area. Groundwater solution would initially dissolve the calcite and clay minerals, and pyrite and the quartz minerals would remain in the host rock. Areas with greater calcite and clay pores would accommodate more groundwater and thus promote a greater surface area for chemical reactions. This enhances the potential for the oxidation of pyrite to form sulphate ions, which can later combine with calcium ions to precipitate gypsum crystals. Alternatively, the oxidation of pyrite, which produces acidity, dissolves the carbonate host and the calcium- and sulphate-rich solution then precipitates gypsum. The combination of the structural and geomorphological processes is key to the formation of economic gypsum deposits. The potential for extensive gypsum reserves within the Steytlerville-Jansenville field remains valid, provided the target is located over a predominantly weathered Whitehill Formation outcrop, preferably in an area which has undergone extensive deformation (such as a fold hinge zone), and is favourable for the concentration of ground and surface water within a low-lying area