ACE-2 HILLCLOUD. An overview of the ACE-2 ground-based cloud experiment.

The ACE‐2 HILLCLOUD experiment was carried out on the island of Tenerife in June–July 1997 to investigate the interaction of the boundary layer aerosol with a hill cap cloud forming over a ridge to the north‐east of the island. The cloud was used as a natural flow through reactor to investigate the dependence of the cloud microphysics and chemistry on the characteristics of the aerosols and trace gases entering cloud, and to simultaneously study the influence of the physical and chemical processes occurring within the cloud on the size distribution, chemical and hygroscopic properties of the aerosol exiting cloud. 5 major ground base sites were used, measuring trace gases and aerosols upwind and downwind of the cloud, and cloud microphysics and chemistry and interstitial aerosol and gases within the cloud on the hill. 8 intensive measurement periods or runs were undertaken during cloud events, (nocturnally for seven of the eight runs) and were carried out in a wide range of airmass conditions from clean maritime to polluted continental. Polluted air was characterised by higher than average concentrations of ozone (>50 ppbv), fine and accumulation mode aerosols (>3000 and >1500 cm−3, respectively) and higher aerosol mass loadings. Cloud droplet number concentrations N, increased from 50 cm−3 in background maritime air to >2500 cm−3 in aged polluted continental air, a concentration much higher than had previously been detected. Surprisingly, N was seen to vary almost linearly with aerosol number across this range. The droplet aerosol analyser (DAA) measured higher droplet numbers than the corrected forward scattering spectrometer probe (FSSP) in the most polluted air, but at other times there was good agreement (FSSP=0.95 DAA with an r2=0.89 for N